Payne Furnace Code 14
Soft lockoutShown as: 1 short flash, 4 long flashes
Ignition lockout. The furnace failed to ignite the gas and prove flame in four attempts. The control auto-resets after 3 hours.
Manual wording: “14 IGNITION LOCKOUT - System failed to ignite gas and prove flame in 4 attempts. Control will auto-reset after 3 hours. See status code 34.”
Documented for: PG92ESA, PG95ESA, PG96VTA, PG80MSU
Likely causes, most common first
- Igniter, flame sensor, or gas valve problem - see code 34
- Low inlet gas pressure or a closed manual gas valve
- Loss of control ground continuity
What you can safely check yourself
- Confirm other gas appliances in the house work, so you know gas service is on
- Turn the furnace off at the service switch for a minute and back on once for one clean retry
When to call a technician
Ignition faults are inside the burner compartment of a live gas appliance. Have a technician check the igniter, flame sensor, gas valve, and gas pressure.
A Payne furnace throwing this code repeatedly has a reason — clearing the code without fixing the cause just hides it.
Sources
- PG92ESA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG92ESA multipoise 92% single-stage condensing gas furnace) · checked 2026-08-25
- PG95ESA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG95ESA multipoise 95% single-stage condensing gas furnace) · checked 2026-08-25
- PG96VTA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG96VTA two-stage, variable-speed ECM 4-way multipoise condensing gas furnace) · checked 2026-08-25
- PG80MSU: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG80MSU 80% multipoise gas furnace with 3-digit display and pressure transducer) · checked 2026-08-25